|
| 
 enlarge | Brand: Sunforce
Category: Automotive Parts And Accessories
List Price: $29.99
Buy New: $24.99
You Save: $5.00 (17%)
New (2) from $24.99
Rating:  18 reviews
Sales Rank: 57
Media: Misc.
Number Of Items: 1
Batteries Included: No
Shipping Weight (lbs): 0.3
Dimensions (in): 4 x 2.3 x 7
MPN: 60012
Model: 60012
UPC: 834319000662
EAN: 0834319000662
ASIN: B0006JO0XI
Release Date: November 25, 2005
Shipping: Eligible for Super Saver Shipping
Availability: Usually ships in 24 hours
|
| Customer Reviews:
 Thanks Amazon for suggesting a product I didn't need !!!! January 14, 2008
1 out of 10 found this review helpful
I CAN'T RATE THIS PRODUCT BECAUSE I REALLY DIDN'T NEED IT. UNFORTUNATELY I MADE THE MISTAKE OF BUYING IT BECAUSE AMAZON HAD IT LISTED IN THIER "BETTER TOGETHER" SECTION (JUST BELOW THE PRODUCT INFORMATION SECTION). APPARENTLY I DIDN'T NEED THIS CHARGE CONTROLLER WITH THE Sunforce 50012 1.8 Watt Solar Battery Maintainer. I FOUND THIS OUT AFTER READING THE INSTRUCTIONS FOR THE CHARGE CONTROLLER, WHEN I RECIEVED IT.
I USUALLY RESEARCH MY PURCHASES THOROUGHLY. THIS TIME I TRUSTED AMAZON. I WILL NOT DO THAT AGAIN!
NOTE: I ONLY GAVE THIS A 4 STAR RATING BECAUSE I COULDN'T SUBMIT A REVIEW WITHOUT THE RATING (4 STARS IS THE CURRENT AVERAGE RATING).
Sunforce 7 amp Solar Controller January 6, 2008
16 out of 16 found this review helpful
Bad:
Really cheap quality. Included instructions don't provide enough information. Website is just as un-informative. Cheap connector wires (low current), and is not equipped with screw-on terminal junctions.
Good: Product works as advertised. Amazinlgly "regulates" the voltage to the required amount so as not to overcharge the battery. Beware though, in order to test the actual output voltage, you must apply a load on the battery end of the controller BEFORE. Failing this, the output can register volts as high as 20 volts !!! Apparently applying an actual load causes the controller to output the correct voltage range - lucky me, cause I bought 4 units ! The LEDS alternately flickers (fast for good voltage input and slow for low to no voltage on solar panel). The manual did NOT state the order of LED flashes.
(1) Fast LED flashes - good voltage/current
(2) Slow LED flashes - low/no voltage/current
(3) steady Green - fully charged
(4) steady amber - possible no load OR really low voltage/current
I recommend you go out and buy 'em. The are a really good deal and does the job at the best price ! I use them in Jamaica, to provide my appliances with power during power outages (very frequent here). Used with solar panels and DC to AC inverter, of course. Considered using a generator, but too many accidents here with generators, too noisy, too bulky, and during hurricane aftermath, fuel is a problem. Solar is freely available, so it was the BEST option all round.
Hope this helps all readers !
Product works well December 25, 2007
4 out of 4 found this review helpful
This item does control the charging of a 12 volt lead-acid battery. I use it with a 75 watt solar panel. The only criticism I have of it is that it doesn't indicate a partial charge. It either indicates that the battery is charging, or that it is fully charged. However, for the price, it is a reasonable buy.
 Charger December 5, 2007
10 out of 10 found this review helpful
I have this unit connect to two automotive 12V batteries with three 15W panels connect to it. So far the charger works as advertised by preventing battery drain when the sun goes down and charging while the panels are producing at least 13 volts. It is pretty much an install and forget item. Additionally I have those same two batteries tied into one of my trucks 12V power points so that the batteries charge when the vehicle is running by way of the alternator. Even with this double charging set up, the charge controller appears unphased and shows a charge light in the daytime and has on two occasions indicated a fully charged green light.
Works great Poor quality control December 3, 2007
3 out of 3 found this review helpful
Once I finally figurd out that it was wired incorrectly internally, the controller works as it is supposed to. The positive and negative wires were reversed and was driving me crazy trying to get it working. Finally I reversed my wiring an it worked.
|
|
|
The Outpost Network | |
