|
| 
 enlarge
| Brand: Pulstar
Category: Automotive Parts And Accessories
Buy New: $49.90
Rating:  30 reviews
Sales Rank: 265
Media: Misc.
Shipping Weight (lbs): 0.3
Dimensions (in): 3.9 x 1.8 x 0.9
MPN: BE1
Model: BE1
UPC: 615099020015
EAN: 0615099020015
ASIN: B000WMHEBE
Shipping: Eligible for Super Saver Shipping
Promotion: Data not available Terms and Conditions
Availability: Usually ships in 24 hours
|
| Customer Reviews:
Pulstar Plugs October 1, 2008
1 out of 1 found this review helpful
These plugs seem to perform OK. No dramatic improvement in fuel economy, however; only a slight improvement. These plugs are extremely fragile when installing them. Be very careful; DO NOT use a spark plug socket - you must use a standard deep well socket or the ceramic will fracture.
 PULSTAR SPARK PLUGS - BEWARE ! September 19, 2008
BEWARE! This product almost destroyed engine. Installed plugs as recommended, drove for approximately one week when suddenly my engine started to stall and engine light came on. Immediately stopped and had vehicle towed. Mechanic stated that one plug ran too hot and destroyed wires with plug also destroyed. Initial cost $80.00, Final cost $350 for tow, new plugs, new wires, and mechanic.
did not work at all September 1, 2008
2 out of 2 found this review helpful
2006 Acura RSX-Type S, 2.0l I-VTEC 4cyl. I followed all instructions, they installed fine, started engine and the plugs immediately threw a CEL. Engine idle timing dropped to 150RPM, car sputtered and stalled, big puff of black smoke from the tailpipe. Started up again, same issue, jumped on the gas and attempted to drive around the block. Stalled twice, idle would not go above 1000RPM (engine has a 7900RPM rev limit). Immediately took them out, replaced with stock IR Denso, which my car was grateful for. All better now, but I don't know what the heck these plugs did. They did not work at all in my car.
Disappointed September 1, 2008
I have a 2003 VW Jetta 1.8t. I gapped these to specification and they ended up frying one of my coil packs. I tried several times to install and get them to work, but they never did.
Perhaps they need a different gapping, but if I'm spending $100 for spark plugs, I shouldn't have to try 3 times to install them.
I hope Pulstar compiles some sort of database that a consumer could look up and see what gapping the plugs need. I read anywhere from .25 to .32 works on my engine (w/ pulstar plugs).
I wish they would have worked.
 A real Improvment August 24, 2008
0 out of 1 found this review helpful
My 2005 Chrysler Crossfire Limited Roadster was starting to run a little rough and thought the quickest way to solve the problem was to change plugs! I recieved the Pulstar Plugs and put them in the same day they arrived, Waht a difference engine runs much smoother and it seems to have more Horsepower!
Thanks to PULSTAR and AMAZON for the power and help!
|
|
|
The Outpost Network | |
